ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
380
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] Valid IP address [-]
Default value 8.8.8.8 Alternative config NO
Step [-]
Comm object 24362 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
The setpoint is used to select the method how the DNS Address 1 is adjusted.
If IP Address Mode (page 378) is FIXED this setpoint is used to adjust the domain name server (DNS),
which is needed to translate domain names in email addresses and server names into correct IP addresses.
If IP Address Mode (page 378) is AUTOMATIC this setpoint is inactive. The DNS server IP address is
assigned by the DHCP server.
DNS IP Address 1
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] Valid IP address [-]
Default value 8.8.8.8 Alternative config NO
Step [-]
Comm object 24331 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
The setpoint is used to select the method how the DNS Address 2 is adjusted.
If IP Address Mode (page 378) is FIXED this setpoint is used to adjust the domain name server (DNS),
which is needed to translate domain names in email addresses and server names into correct IP addresses.
If IP Address Mode (page 378) is AUTOMATIC this setpoint is inactive. The DNS server IP address is
assigned by the DHCP server.
DNS IP Address 2
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65