ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
546
Related FW 1.9.0 Related applications AMF, MRS
Comm object 1260
Description
This output is active when the Wrn Charging Alternator Fail (page 655) alarm is present in the alarmlist or
isn’t confirm.
AL D+ Fail
6 back to Logical binary outputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 2098
Description
This LBO is active when there is alarm of 2nd level on Master controller.
AL Dual Master Fail
6 back to Logical binary outputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 2099
Description
This LBO is active when there is alarm of 2nd level on Slave controller.
AL Dual Slave Fail
6 back to Logical binary outputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 1294
Description
This output is active when the Sd Earth Fault Current (page 674) alarm is present in alarm list or isn’t
confirm.
Note: It is strongly recommended to use this output only onetime.
AL Earth Fault
6 back to Logical binary outputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 1548
Description
This output is active when the Wrn Fence 1 Alarm (page 656) or BOC Fence 1 Alarm (page 683) or Sd
Fence 1 Alarm (page 675) (depends on configuration of alarm type) alarm is present in the alarmlist or isn’t
confirm.
AL Fence 1
6 back to Logical binary outputs alphabetically

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65