EasyManua.ls Logo

ComAp InteliLite NT AMF Series - Page 55

ComAp InteliLite NT AMF Series
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
InteliLite
NT
– AMF20/25, SW version 1.2, ©ComAp – March 2008 55
IL-NT-AMF-Reference Guide1.2.pdf
Type Channel 1,2 [ DISABLED, SMS, E-MAIL ]
TelNo/Addr Ch1, 2
Enter either a valid GSM phone number or e-mail address to this setpoint, where the alarm messages
shall be sent.
Hint:
For GSM numbers use either national format (i.e. like number you will dial if you want to make a local
call) or full international format with "+" character followed by international prefix in the begin.
This setpoint can be modified from PC only!
NumberRings AA [ - ]
Number of rings prior to open modem connection.
Step: 1
Range: 1 – 30
Hint
:
NumberRings AA change is not activated immediately. It is activated after the controller is switched on
or when modem is connected to the controller.
ActCallAttempt [ 1 to 250 ]
When active call is activated, controller tries five times to open the connection when
ActCallAttempt
= 1 (e.g. when the phone line is engaged).
There are ten attempts when ActCallAttempt = 2, etc.
Step: 1
Range: 1 to 250
Hint
:
There are 5 attempts for any active call. Timeout for connection is 90 sec and after 120 sec controller
starts the next attempt. During the time the IL-NT is trying to send an active call type, incoming calls
are blocked.

Table of Contents

Related product manuals