InteliLite
NT
– AMF20/25, SW version 1.2, ©ComAp – March 2008 6
IL-NT-AMF-Reference Guide1.2.pdf
General Description
Description of the controller system (with all options)
InteliLite
NT
AMF20/25 is a comprehensive AMF-controller for single generating sets operating in stand-
by mode. IL-NT AMF25 features extended support of electronic engines and extension modules.
InteliLite
NT
controllers are equipped with a powerful graphic display showing icons, symbols and bar-
graphs for intuitive operation, which sets, together with high functionality, new standards in Gen-set
controls.
InteliLite
NT
automatically starts the Gen-set, closes the Gen-set C.B. when all conditions are met, then
stops the engine on external signal or by pressing push buttons.
InteliLite
NT
provides gas engine support without ventilation.
The key feature of InteliLite
NT
is its easy-to-use operation and installation. Predefined configurations
for typical applications are available as well as user-defined configurations for special applications.
What is in the package?
Accessories Description Optional / Obligatory
IL-NT AMF InteliLite
NT
central unit Obligatory
IL-NT RS232 RS232 communication card Optional for AMF20/25
IL-NT AOUT8 Gauge driver card Optional for AMF20/25
*IL-NT RD (SW) Remote display software Optional for AMF20/25
IGL-RA15 Remote annunciator Optional for AMF20/25
IG-IOM/PTM I/O extension module Optional for AMF25
IG-IB Internet communication bridge Optional for AMF20/25
AT -LINK-CONV Service programming RS232
interface
Optional for AMF20/25
*Remote display for IL-NT controllers uses standard IL-NT controller with Remote
display software
IL-NT RS232 communication module
IL-NT RS232 is optional plug-in card to enable InteliLite
NT
for RS232 communication. This is required
for computer or Modbus connectin. Card inserts into expansion slot back on the controller.
To insert the module, you must open the cover first (use screwdriver to open) and then insert the
module into slot. Once you have insert it, the module will snap under plastic teeth. It is supposed to be
installed permanently. Should you need to remove it, the safest way is to remove whole back cover
and than remove module manually.
To Next Page
Loading...
