ComAp InteliLite NT AMF Series - Page 8

84 pages

To Next Page

To Previous Page

InteliLite

IL-NT-AMF-Reference Guide1.2.pdf

4. Break apart the small cover into two pieces. Do not throw away the smaller part!

5. Take RS 232 communication module.

Main Page

Table of Contents2
General Guidelines4
- What Describes this Manual4
- Warnings4
- Text4
General Description6
- Description of the Controller System (with All Options)6
- What Is in the Package6
- IL-NT RS232 Communication Module6
- IL-NT AOUT8 Gauge Driver Module10
- IL-NT RD (SW) Remote Display Software10
- Remote Announciator IGL - RA1510
- IG IOM/PTM Module11
- IG-IB Internet Bridge13
IL-NT Terminals14
- IL-NT Terminals and Face14
Recommended Wiring15
- AMF - Wiring Diagram15
Contactors (Set Point MCB Logic = "CLOSE-OFF")16
ATS with Two Stable Positions (Set Point MCB Logic = "CLOSE-ON")16
Stand-By Applications16
ATS with Three Stable Positions (Set Point MCB Logic = "CLOSE-OFF")17
Getting Started18
- How to Install18
- Current Measurement21
- Voltage Measurement22
- Single Phase Applications22
- Analog Inputs23
- Extension Modules (CAN Bus) Connection27
- Analog Outputs28
Inputs and Outputs29
- Binary Inputs IL-NT - Default29
- Binary Inputs - List29
- Binary Outputs IL-NT - Default32
- Binary Outputs - List32
- Analog Inputs39
Setpoints41
- Password41
- Basic Settings41
- Engine Params43
- Engine Protect45
- Gener Protect47
- Automains Fail49
- Date/Time52
- Sensor Spec53
- Extension I/O54
- Act Calls/Sms54
ECU-Controlled Engine Support56
- Values Read from ECU57
- Diagnostic Messages Read from ECU57
- Analog Inputs58
- Connection Description58
Sensor Specification61
- Background of the Sensor Calibration61
- Default Sensor Curves61
Function Description62
- OFF Mode62
- MAN Mode62
- AUT Mode64
- TEST Mode64
- Circuit Breakers Timing65
Alarm Management67
- Sensor Fail (FLS)67
- Warning (WRN)67
- Shut down (SD)67
- Mains Failure (MF)67
Gen-Set Operation States70
- List of Possible Events70
- History File72
Remote Control and Data Logging73
- Direct Connection to the PC73
- PC Software - Liteedit73
- Modbus Protocol73
Remote Communication79
- Internet Connection79
- Recommended ISDN Modem79
- Recommended GSM Modem79
- Mobile SIM Card Setting79
Technical Data80
- Power Supply80
- Operating Conditions80
- Low Temperature Modification80
- Dimensions and Weight81
- Mains and Generator81
- Binary Inputs and Outputs81
- Analog Inputs81
- Speed Pick-Up Input82
- D+ Function82
- CAN Bus Interface82
- IL-NT RS232 Interface (Optional Card)83
- IL-NT AOUT8 Interface (Optional Card)83
- Igs-Ptm83
- Igl-Ra1583
- Ig-Ib84

ComAp InteliLite NT AMF Series - Page 8

Table of Contents

Related product manuals