InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
This setpoint is used to enable/disable evaluation of collisions of virtual
shared peripherial modules. A collision means that there is more than one
source (shared outputs module) active on the CAN2 bus.
NOTE:
In certain situations multiple sites with bus tie breakers may need to have
more shared outputs sources as the CAN bus line is in some points
interrupted according to bus tie breakers position. Normally a collision would
be indicated if there were more sources on the bus and this setpoint can be
used to disable the evaluation of collisions in this special case.
11.2.3.15 Setpoint: CANAddrSwitch1
The setpoint selects function of the terminal address 122 at the CAN2 line.
See the latest communication guide for details about this topic.
The address is used for modem connection via I-LB
The address is used for direct connection to any other device
as e.g. IV8 or I-RD.
11.2.3.16 Setpoint: CANAddrSwitch2
The setpoint selects function of the terminal address 125 at the CAN2 line.
See the latest communication guide for details about this topic.
The address is used for modem connection via I-LB
To Next Page
Loading...