InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
reset again when they become inactive.
Pressing of the fault reset button (at any terminal or
external button) resets all alarms that are currently
present in the alarm list. Inactive alarms disappear from
the alarm list immediately, active alarms are changed to
"confirmed" state and disappear when the alarm condition
disappear or the alarm starts to be blocked.
NOTE:
ENABLED position corresponds to the method how the IG-classic and IS-
classic controllers handled the alarms.
11.2.5 Group: Analog protect
11.2.5.1 Setpoint: Batt >V
This setpoint adjusts the warning level for battery overvoltage alarm.
11.2.5.2 Setpoint: Batt <V
This setpoint adjusts the warning level for battery undervoltage alarm.
11.2.5.3 Setpoint: Batt volt del
To Next Page
Loading...