InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.12.4 Value: AIN CU-2
This is the value of the analog input 2 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for water temperature measurement.
12.1.12.5 Value: AIN CU-3
This is the value of the analog input 3 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for fuel level measurement.
12.1.12.6 Value: AIN CU-4
This is the value of the analog input 4 of the controller. Analog inputs are fully
configurable so the name and units depend on configuration. In the default
configuration the input is used for fuel level measurement.
12.1.13 Group: Bin inputs CU
12.1.13.1 Value: BIN
This is a bit array containing status of physical binary inputs of the controller.
Bit0 represents BI1, bit1 represents BI2 etc..
NOTE:
To Next Page
Loading...
Need help?
General