InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
12.1.14 Group: Bin outputs CU
12.1.14.1 Value: BOUT
This is a bit array containing status of physical binary outputs of the
controller. Bit0 represents BO1, bit1 represents BO2 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
12.1.15 Group: Log Bout
12.1.15.1 Value: LogBout 1
This is a bit array containing status of logical binary outputs 1-16 of the
To Next Page
Loading...