InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
11.2.3.31 Setpoint: DNS IP
In fixed settings mode this setpoint is used to adjust the domain
name server (DNS), which is needed to traslate domain names in e-
mail addresses and server names into correct IP addresses.
In Automatic settings mode this setpoint is used to display DNS
server, which has been assigned by the DHCP server. It is not
possible to change the setpoint value manually in this setting (the
value is immediately reverted back by controller communication
module IB-COM).
11.2.4 Group: ComProtSetting
11.2.4.1 Setpoint: Horn Timeout
OFF, 1s - 3600s, NO TIMEOUT [-]
This setpoint adjusts time after which the Horn output is automatically
deactivated although the alarms still haven't been reset. If the setpoint is
adjusted to OFF the horn output is not activated at all, the NO TIMEOUT
position means the horn output is not deactivated until the alarms are reset.
11.2.4.2 Setpoint: BinInp delay 1
To Next Page
Loading...