InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
6 Firmware and Archives
Since the version 3.0, controller firmware was differentiated for BaseBox type controllers and GC
(Graphical Character, with built-in display) controllers. These firmwares are compatible but their
functions differ slightly. It is not possible to upload BaseBox type firmware to GC controller and vice
versa.
6.1 BaseBox type controllers
InteliMains-NT-BaseBox and InteliMains-NTC-BaseBox
The firmware for these controllers has specific functions available which are not available in Graphical
Character type controllers. The list of BaseBox-exclusive function is as follows:
Peak Shaving based on kVA
Distributed Binary Inputs and Outputs
User MODBUS
6.2 Graphical Character type controllers
The firmware for GC controllers do not support functions described above, although it can still be used
in combination with BaseBox type controllers.
NOTE:
It is possible to use specialized InteliMains-NT firmware for InteliSys controllers. This firmware
supports all the functions mentioned above.
To Next Page
Loading...