InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
This setpoint is used for entering the domain name (e.g.
smtp.yourprovider.com) or IP address (e.g. 74.125.39.109) of the SMTP
server. Please ask your internet provider or IT manager for this information.
NOTE:
You may also use one of free SMTP servers, e.g. smtp.gmail.com. However,
please note that some free SMTP servers may cause delays (in hours..)
when sending e-mails.
NOTE:
If you do not want to send active e-mails, you may leave this setpoint blank,
as well as other setpoints related to SMTP server and e-mail settings.
11.2.3.29 Setpoint: Contr mailbox
Enter an existing e-mail address into this setpoint. This address will be
used as sender address in active e-mails that will be sent from the controller.
Do not enter your or other recipient's e-mail address. Recipient's addresses
are to be entered into the setpoints AcallCH1-Addr, AcallCH2-Addr and
AcallCH3-Addr.
NOTE:
Most of SMTP server will reject sending e-mails that contain nonexisting
address in the sender address field.
11.2.3.30 Setpoint: Time zone
This setpoint is used to select the time zone where the controller is located.
See your computer time zone setting (click on the time indicator located in
the rightmost position of the the windows task bar) if you are not sure about
your time zone.
NOTE:
If the time zone is not selected properly the active e-mails may contain
incorrect information about sending time, which may result in confusion when
the respective problem actually occured.
To Next Page
Loading...