ComAp InteliMains NT IM-NT-BB - Page 288

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
288
11.2.15.5 Setpoint: MainsP w/Reset
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
MainsP w/Reset-type alarm occurs. See the chapter Alarm management for
more information about protection types.
11.2.15.6 Setpoint: AcallCH1-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 1.
See the chapter Alarm messaging for more details.
11.2.15.7 Setpoint: AcallCH1-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
standard v3.1.0
Description
The setpoint is used to specify the recipient address for the active calls -
channel 1. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.