ComAp InteliMains NT IM-NT-BB - Page 287

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
287
11.2.15.2 Setpoint: Alarm only
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
"protection" configured as Alarm only occurs. See the chapter Alarm
management for more information about protection types.
11.2.15.3 Setpoint: Warning
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
standard v3.1.0
Force value
possible
YES
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
warning-type protection occurs. See the chapter Alarm management for more
information about protection types.
11.2.15.4 Setpoint: Mains protect
Group
Act. calls/SMS
Range [units]
DISABLED, ENABLED [-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint is used to enable sending SMS and/or e-mail alerts when a
"protection" configured as Mains protect occurs. See the chapter Alarm
management for more information about protection types.
NOTE:
As the Mains protect protection does not appear in the alarmlist, the SMS or
e-mail may contain empty alarmlist.