ComAp InteliMains NT IM-NT-BB - Page 208

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
208
Range [units]
0.0 .. 60.0 [s]
Related FW
standard v3.1.0
Description
This setpoint adjusts the delay after the binary input Force block 1 has been
deactivated, when the alarms configured as Force block #1 are started to be
evaluated.
11.2.4.6 Setpoint: ForceBlockDel2
Group
ComProtSetting
Range [units]
0.0 .. 60.0 [s]
Related FW
standard v3.1.0
Description
This setpoint adjusts the delay after the binary input Force block 2 has been
deactivated, when the alarms configured as Force block #2 are started to be
evaluated.
11.2.4.7 Setpoint: ForceBlockDel3
Group
ComProtSetting
Range [units]
0.0 .. 60.0 [s]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint adjusts the delay after the binary input Force block 3 has been
deactivated, when the alarms configured as Force block #3 are started to be
evaluated.
11.2.4.8 Setpoint: ResetActAlarms
Group
ComProtSetting
Range [units]
[-]
Related FW
standard v3.1.0
Description
DISABLED
Pressing of the fault reset button (at any terminal or
external button) resets only inactive alarms. Active
alarms remain in the alarmlist unchanged and must be