InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.4.3 Value: TotRun Ld char
This value shows total load character of all running gensets in group
controlled by IM-NT (e.g. in one logical group or in two logical groups linked
by Group link).
12.1.4.4 Value: Gen-set1 pwr
This value shows the actual power of corresponding genset (i.e. power of
genset with CAN address 1 is shown in Gen-set1 pwr). If genset with
corresponding address is not available (does not exist of function on the CAN
bus) value "#####" is diplayed.
12.1.4.5 Value: Gen-set2 pwr
This value shows the actual power of corresponding genset (i.e. power of
genset with CAN address 1 is shown in Gen-set1 pwr). If genset with
corresponding address is not available (does not exist of function on the CAN
bus) value "#####" is diplayed.
12.1.4.6 Value: Gen-set3 pwr
This value shows the actual power of corresponding genset (i.e. power of
genset with CAN address 1 is shown in Gen-set1 pwr). If genset with
corresponding address is not available (does not exist of function on the CAN
To Next Page
Loading...