Comelit 8472MC - Advanced Programming Methods; Direct Intercom Call Setup; Monitor Ringtone Selection

3232
EN
Direct programming of intercom call
Allows direct programming of intercom call via the internal units.
√ Requires 2 operators.
Step 1: enter programming mode
Operator 1 and Operator 2 carry out the following procedures on
2 internal units:
1. Set S2 DIP switches 1-2 -3-4 to the combination 1111.
2. Lift the handset.
3. Press and hold buttons 1 and 2 for 3 sec.
» The internal unit emits 1 tone.
» The green LED fl ashes.
» The internal unit enters audio mode.
» At this point the 2 operators will be communicating with each other.
____
Step 2: intercom call programming
Operator 1:
` Press the button you want to program to call operator 2 (e.g. 2).
» The internal unit manned by operator 1 emits a confi rmation tone.
Operator 2:
` Press the button you want to program to call operator 1 (e.g. 1).
» The internal unit manned by operator 2 emits a confi rmation tone.
Operator 1/Operator 2:
` Hang up the handset.
» The internal unit emits 1 tone.
» Programming of the 2 internal units is now complete.
To program another internal unit, move on to STEP 3.
____
Step 3: programming other internal units
Operator 1/Operator 2:
1. Once the new station has been reached, carry out step 1 to begin
communication.
2. Repeat step 2.
NOTE If a call is received during programming, it must be answered
and the programming procedure resumed afterwards.
Monitor ringtone selection
1. Press and hold button A until a confi rmation tone is emitted (this
procedure is only possible with the system in standby; otherwise the
LED indicator will fl ash to warn the user).
2. Press and release button A :
once (1 confi rmation tone is emitted) to change the ringtone of calls
from the external unit.
twice (2 confi rmation tones are emitted) to change the ringtone for calls
from the switchboard.
3 times (3 confi rmation tones are emitted) to change the ringtone for
intercom calls made from the internal unit.
4 times: (4 confi rmation tones are emitted) to change the fl oor door call
ringtone.
Any further pressing of button A repeats the sequence described
above.
3. Press and release button 1 to scroll through the various available
ringtones in sequence.
4. Press button 2 to confi rm selection of the last ringtone heard and to exit
(at any time) the monitor ringtone change mode. On exiting the monitor
ringtone selection mode a confi rmation tone will be emitted.