Compex CGX3224 User Manual

Chapter 2 Hardware Installation
8
3. Connect the power cord to the power socket on the rear panel of Compex
CGX3224.
NOTE
For proper ventilation, do allow about 4 inches of clearance on the front and back
of the switch. This is especially important in an enclosed rack.
2.1.3 Expansion Module Installation
A series of optional expansion modules are available for Compex CGX3224
to upgrades its features. Please note that Compex CGX3224 is not shipped
with the Gigabit modules.
1. Power off the switch. Insert the module carefully into the expansion
module window and push it along the module rail until it stops. Ensure
that there is a secure connection to the PCB Board of Compex CGX3224.
2. Tighten the screws on the module.
2.1.4 Removing the Expansion Module
1. Power off the switch.
2. Disconnect any cable from the module.
3. Unscrew and pull out the module slowly from the expansion module slot.
4. Slide the module completely out of the chassis and cover the window with
the cover plates, fasten back using the original screws.

Compex CGX3224 Specifications

General

Brand	Compex
Model	CGX3224
Category	Switch
Language	English