Chapter 5 Configure Compex CGX3224 using Web Interface
25
5.5 WAN Configuration
Compex CGX3224 is pre-configured as WAN disabled. It can support Static IP,
Dynamic IP and also PPP Over Ethernet.
If you have chosen self-installation when you register for the broadband service, you
should first test the ADSL modem together with the logon account. Make sure that it
can connect successfully before attempting to run it with Compex CGX3224. For
purpose of illustration, it is assumed that LAN uses the IP address 192.168.100.xxx and
Compex CGX3224 is using the same settings as defaults. However, if you have
assigned a different IP address for Compex CGX3224, then use the new settings in the
setup procedures.
Description of parameters
WAN Port
You may configure any 4 of the 24 ports as WAN port and connect to
your ADSL/Cable modem.
WAN Type
Static IP Address:
Select this WAN type if you have subscribed to a specific IP address
or to a fixed range of IP addresses from your ISP.
Dynamic IP Address:
This IP address is automatically assigned by your ISP. This type of
connection applies to most Cable Internet subscribers such as:
• Singapore Cable Vision subscribers.
• @HOME Cable Service users.
PPPoE:
Select this connection type if you have subscribed to ADSL in a
country utilising standard PPPoE for authentication, for instance:
• If you are in Germany which uses T-1 connection.
• If you are a SingNet Broadband or Pacific Internet Broadband
user in Singapore.
To Next Page
Loading...
Need help?
General
