Chapter 5 Configure Compex CGX3224 using Web Interface
17
Description of parameters
Broadcast Rate
Limit
This function sets broadcast limit to the desired rate for the
specified port. It controls the reception of broadcasting packets.
The range for Broadcast Rate Limit can be set from 0% to 100%.
The higher the rate, the more data can pass through.
Port Priority
Allows you to specify the VLAN priority to expedite the VLAN
traffic.
Port VLAN ID
VLAN ID is the sequence number of a VLAN. Compex CGX3224
has 32 VLANs to specify and therefore the VLAN ID is from 1 to
4091.
Port State
Enabling this function allows the chosen port to receive, forward
packets, and learn the respective MAC Addresses of the source.
Flow Control
This feature reports the Flow Control setting of the port. Enabling
the Flow Control function allows Half and Full Duplex mode.
NOTE
If the port (management port) that is connected to your management PC has
disabled, the communication link between users and the management system will
be severed and the management cannot be proceed further. So, disabling the
management port will be rejected automatically by the management system.
Procedures
1. Go to Port Config from the Command window.
2. Click on the image to select a port or select from the ‘Choose Port’ field.
3. Enter the values in the respective field accordingly and click on the Apply button to
make the configuration effective.
4. Hit the Save button if you are satisfied with the setting.
NOTE
The screen is divided into two sections. The Port Statistics page displays detailed
information about each port. Click Refresh button to view the current port status
of Compex CGX3224.
To Next Page
Loading...
Need help?
General
