Comtech EF Data CSAT-5060 - Snm=; Spa=

CSAT-5060 C-Band Transceivers Revision 1
Appendix A MN/CSAT5060.IOM
A–24
CSAT with Ethernet Remote Commands
Parameter
Type
Command Arguments Description of arguments Response to Command Query
Response to
query
Retrieve Firmware
Number for the
Ethernet board
N/A
variable length
Query only
Returns the firmware type loaded into the unit.
Example:
>0001/FRM=
Boot:
FW-0000082;0.0.1a;04/09/08
Bulk1:
FW-0020597-;1.1.1 ;05/02/12
Bulk2:
FW-0020597-;1.1.1 ;05/02/12
N/A
FRM?
FRM=x
See Note 2
SNMP Read
Community
SRC=
20 bytes,
characters, no
spaces
Command or Query.
SNMP read community string. Empty string is not
allowed
Example: <1/SRC=public
SRC=
SRC?
SRC?
SRC =x
See Note 2
SNMP
System Contact
SSC=
20 bytes,
characters
Command or Query.
SNMP System Contact string.
Example: <1/SSC=Joe Net Admin.
If not configured it returns empty string: <1/SSC=
SSC=
SSC?
SSC?
SSC =x [1..20]
See Note 2
SNMP
System
Location
SSL=
20 bytes,
characters
Command or Query.
SNMP System Location string
Example: <1/SSL=Upstairs back right.
If not configured it returns empty string. <1/SSL=
SSL=
SSL?
SSL?
SSL =x [1..20]
See Note 2
SNMP
Unit Name
SSN=
20 bytes,
characters
Command or Query.
SNMP System Name string
Example: <1/SSN=Remote1.
If not configured it returns empty string. <1/SSC=
SSN=
SSN?
SSN?
SSN =x [1..20]
See Note 2
SNMP Trap
Destination IP
Address 1
STA=
15 bytes,
Numerical
Command or Query.
Used to set the IP address of the first SNMP Trap
destination IP Address 1 where traps will be sent where
the form xxx.xxx.xxx.xxx is the IP addresss
Example: <1/STA=010.006.030.001
When not configured, returns >0001/STA=0.0.0.0
STA =
STA?
STA?
STA=xxx.xxx.xxx.x
xx
See Note 2