Comtech EF Data CSAT-5060 - Sna=

CSAT-5060 C-Band Transceivers Revision 1
Appendix A MN/CSAT5060.IOM
A–23
CSAT with Ethernet Remote Commands
Parameter
Type
Command Arguments Description of arguments Response to Command Query
Response to
query
Unit MAC Address
N/A
17 bytes
Query Only
MAC address of the unit, reported in hexadecimal.
Example: MAC=00-06-B0-00-D2-A7
N/A
MAC?
MAC=xx-xx-xx-xx-
xx-xx
See Note 2
Time Protocol
Enable
TPE=
1 byte
Command or Query.
Current Active software image, where:
0 = Time protocol disabled
1 = Time protocol enabled
Example: TPE=1 (Time protocol enabled)
TPE=
TPE?
TPE?
TPE=x
See Note 2
Time Protocol
Server
TPS=
15 bytes
Used to set the Time Server IP address for the
Unit. Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the Time server IP address
Example: IPG = 192.168.001.005
TPS=
TPS?
TPS?
TPS=
xx.xxx.xxx.xxx.yy
See Note 2
Local/
Remote
Status
LRS=
1 bytes
Command or Query.
Used set the user’s Local/Remote status in the form x,
where:
1=Serial Remote (RS-232/RS-485)
2=Ethernet
3=Ethernet and Serial
4=FSK
Example: LRS=1 (selects Serial Remote)
Note: Changing LRS to FSK mode may cause some
serial remote commands reply with # code (hardware
resource issues).
LRS=
LRS?
LRS?
LRS=x
See Note 2
Part Number
N/A
variable length
1 – 95 bytes
Query only
Returns the Comtech EF Data part number of the unit.
This
part number is the unit’s DOTCODE at the time it was
manufactured. The DOTCODE may be up to 95 printable
ASCII characters long.
Example: <1/PNM?’cr’
>0001/PNM=CSAT5060-005’cr’’lf’
N/A
PNM?
PNM=x[1..95]
See Note 2