EasyManua.ls Logo

Comtech EF Data CSAT-5060 - Rtg=

Default Icon
226 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CSAT-5060 C-Band Transceivers Revision 1
Appendix A MN/CSAT5060.IOM
A–14
CSAT Remote Commands
Parameter
Type Command Arguments Description of arguments
Response to
Command Query
Response to
Query
Redundancy
Controller Box
Toggle
RTG= None Command only.
RTG= sent to the online CSAT will cause the Redundancy
Box to toggle the TX and RX switches.
Example: RTG=
RTG= (message ok)
RTG? (received ok, but
invalid arguments
found)
N/A
N/A
Remote Address
(Physical Address)
SPA= 4 bytes,
numerical
Command or Query.
Physical Address - between 0001 and 9999.
Resolution 0001.
Example: SPA=0890
SPA= (message ok)
SPA? (received ok, but
invalid arguments found)
SPA? SPA=xxxx
See Note 1
Remote Baud rate SBR= 4 bytes Command or Query.
Baud Rate, as follows:
1200 = 1200 baud,
2400 = 2400 baud,
4800 = 4800 baud,
9600 = 9600 baud,
19K2 = 19200 baud.
38K4 = 38400 baud.
Note: Unit responds on the existing baud rate and then
changes to the new baud rate.
SBR= (message ok)
SBR? (received ok, but
invalid arguments found)
SBR? SBR=xxxx
See Note 1
Set RTC Date DAY= 6 bytes,
numerical
A command in the form mmddyy, where; dd = day of the
month, between 01 and 31, mm = month of the year,
between 01 and 12 and yy = year, between 97 and 96
(1997 to 2000, then 2000 to 2096)
Example: DAY=042457 would be April 24, 2057
DAY= (message ok)
DAY? (received ok, but
invalid arguments found)
DAY* (message ok, but
not permitted in current
mode
DAY? DAY=xxxxxx
See Note 1
Set RTC Time TIM= 6 bytes,
numerical
A command in the form hhmmss, indicating the time from
midnight, where hh = hours, between 00 and 23; mm =
minutes, between 00 and 59, and ss = seconds, between
00 and 59
Example: TIM=231259 would be 23 hours, 12 minutes and
59 seconds from midnight.
TIM= (message ok)
TIM? (received ok, but
invalid arguments found)
TIM* (message ok, but
not permitted in current
mode
TIM? TIM=xxxxxx
See Note 1
Clear All Stored
Alarms
CAA= None Command only
Instructs the slave to clear all Stored Events
This command takes no arguments.
CAA= (message ok)
N/A
N/A

Table of Contents