CSAT-5060 C-Band Satellite Transceivers Revision 1
Table of Contents MN/CSAT5060.IOM
iv
2.1 Dimensional Envelope ....................................................................................................................... 2-1
2.2 Specifications ...................................................................................................................................... 2-7
CHAPTER 3. CONNECTOR PINOUTS ................................................................................. 3–1
3.1 Pin-outs .............................................................................................................................................. 3–1
3.1.1 Connector J3: AC Power, Mains, 100 to 125 VAC, or 205 to 240 VAC. .................................. 3–1
3.1.2 Connector J5: COMM, Remote communications port ................................................................ 3–2
CHAPTER 4. SYSTEM OPERATION .................................................................................... 4–1
4.1 Turning On the CSAT ...................................................................................................................... 4–1
4.2 Configuring the CSAT ...................................................................................................................... 4–1
4.2.1 Frequency ..................................................................................................................................... 4–1
4.2.2 Attenuation ................................................................................................................................... 4–2
4.2.3 Gain Offset ................................................................................................................................... 4–2
4.2.4 Mute Mode ................................................................................................................................... 4–2
4.2.5 Mute ............................................................................................................................................. 4–3
4.2.6 Tx Amplifier ................................................................................................................................ 4–3
4.2.7 Channel Slope Adjust Mode ........................................................................................................ 4–3
4.2.8 Channel Slope Adjust................................................................................................................... 4–4
4.2.9 Reference Frequency Adjust ........................................................................................................ 4–4
4.2.10 External Reference Fault Logic ................................................................................................. 4–4
4.2.11 Cold Start Function .................................................................................................................... 4–5
4.2.12 Auto Fault Recovery .................................................................................................................. 4–5
4.2.13 LNA Current Source .................................................................................................................. 4–6
4.2.14 LNA Current Calibration and Current Window ......................................................................... 4–6
4.2.15 LNA Fault Logic ........................................................................................................................ 4–6
4.2.16 Redundancy Controller Auto/Manual ........................................................................................ 4–7
4.2.17 Redundancy Controller Toggle .................................................................................................. 4–7
4.2.18 Set Physical Address .................................................................................................................. 4–7
4.2.19 Set Baud Rate ............................................................................................................................. 4–8
4.2.20 Set Date ...................................................................................................................................... 4–8
4.2.21 Set Time ..................................................................................................................................... 4–8
CHAPTER 5. REDUNDANT SYSTEMS ................................................................................ 5–1
5.1 Redundant System ............................................................................................................................ 5–1
5.1.1 RSU-5060 Interfaces .................................................................................................................... 5–2
5.1.1.1 Electr
ical Interface ............................................................................................................................................ 5–2
5.1.1.2 CSAT Unit A Interface, J1 .............................................................................................................................. 5–2
5.1.1.3 Rx Waveguide Switch interface, J2 ............................................................................................................... 5–3
5.1.1.4 CSAT Unit B Interface, J3 .............................................................................................................................. 5–3
5.1.1.5 Tx Waveguide Switch interface, J4 ............................................................................................................... 5–4
5.1.1.6 M&C Interface, J5 ............................................................................................................................................ 5–4
5.1.1.7 Tx IF Interfaces, J6, J7, and J8 ...................................................................................................................... 5–5
5.1.1.8 Rx IF Interfaces, J9 – J11 ................................................................................................................................ 5–5
To Next Page
Loading...