AA–1
Addendum A. ETHERNET-
BASED REMOTE PRODUCT
MANAGEMENT
AA.1 Introduction
Ethernet-based Remote Product Management of the unit is available using the J8 port.
To proceed with Ethernet-based Remote Product Management, make sure that:
• The unit is operating with the latest version firmware files.
• The unit is connected to a user-supplied Windows-based PC as follows:
• The PC’s Ethernet port is connected to the unit J8 port with RJ-45 cable.
• The PC is running a terminal emulation program (for operation of the unit
remote control Telnet interface).
• Use the remote serial query to find and record the IP Address.
See also the Remote Commands and Queries specifications tables found in Chapter 5.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT.
To Next Page
Loading...