Startup Sequence for EverSmart/EverSmart Pro 19
3.2 Startup Sequence for EverSmart/EverSmart Pro
When you switch on the scanner, the Light LED on the operating
panel is green. During the diagnostic self-tests, the Status LED
illuminates according to various stages, as follows:
• The Status LED is red for several seconds when the scanner is
switched on.
• The Status LED turns off for several seconds while the
scanner checks the power supply.
• The Status LED blinks green for approximately 30 seconds
while the scanner performs self-diagnostics. If this step is
completed successfully, the LED remains green.
For EverSmart Pro scanners only - the Light button on the
operating panel is used to switch the light table on and off, when the
top cover of the scanner is open.
3.3 Startup Sequence for EverSmart Pro II/EverSmart
Supreme
When you switch on the scanner, the Light LED on the operating
panel is green. During the diagnostic self-tests, the Status LED
illuminates according to various stages, as follows:
• The Status LED lights red for approximately 12 seconds when
the scanner is switched on.
• The Status LED blinks once while the scanner checks the
power supply.
• The Status LED is green if this step is completed successfully.
The Light button on the operating panel is used to switch the light
table on and off, when the top cover of the scanner is open.
To Next Page
Loading...