92
This page is intentionally left blank.
1. Add bypass C-tag, 802.1p & DSCP
remarking, QoS VID mode & VID
Mapping, SSH, DHCP Snooping &
DHCP server trust port commands.
2. 32 VLANs → 128 VLANs
Add P-bit marking commands,
management traffic commands, VLAN
pass-through commands, Q-in-Q
Management VLAN Limitation, loop
detection description, and CATV
module status and CATV State Trap.
Add new functions: NTP Time Server,
Port-Isolation, MAC Address Table,
SNMP trap for CATV F/O level, DHCP
Vendor ID, Show Log, Auto-
Provisioning, and Loop Detection
Change LED definitions of System
Status (Default and Restart)
Add Web Management
Proofreading
The initial version.