English – 5
Displaying/adjusting basic settings
Note: The settings menu cannot be called up while riding.
To get to the basic settings menu, press the
select button
on the operating unit repeatedly until <Settings> appears in
the text display.
Switching/Leaving Basic Settings
Press the or button repeatedly until the
required basic setting is displayed.
Press the select button repeatedly until the
required basic setting is displayed.
Note: The changed setting is automatically saved upon leav-
ing the respective basic setting.
Changing Basic Settings
To scroll down, briefly press the select but-
ton until the required value is displayed.
To scroll down, press the select button>1s
until the required value is displayed.
Note: Pressing and holding the relevant button switches
automatically to the next value in the basic settings.
You can choose between the following basic settings:
– <Trip reset?>: All data on the journey so far is reset to
zero.
– <Language>: Here you can select a preferred language
from the following options:
English, German, French, Dutch, Italian, Spanish, Por-
tuguese, Danish, Swedish, Norwegian, Polish, Czech, Ja-
panese, Traditional Chinese for Taiwan, Korean.
– <Units>: Displays the speed and distance in either kilo-
metres or miles.
– <Time>: You can set the time here.
– <Time format>: Displays the time in 12-hour or 24-hour
format.
– <Shift recom.>: You can switch on/off the display of gear
change recommendations.
– <Backlight.>: You can set the duration of the back-
ground lighting here.
– <Brightness>: The brightness can be adjusted to various
levels.
– <Reset settings?>: You can reset the settings by press-
ing and holding the select button here.
– <Back>: You can leave the settings menu with this func-
tion.
Leaving the Basic Settings Menu
You leave the basic settings menu automatically if you are in-
active for 60s or start riding the eBike, or by using the
<Back> function.
Briefly press the select button to leave the
basic settings menu using the <Back> function.
Press the select button>1s to leave the ba-
sic settings menu using the <Back> function.
Maintenance and servicing
Maintenance and cleaning
Do not clean any of the components with pressurised water.
Keep the display of your on-board computer clean.
Clean your on-board computer using a soft cloth dampened
only with water. Do not use cleaning products of any kind.
Note: TheIntuvia 100 on-board computer may fog up under
certain temperature and humidity conditions. This is not an
error. Put the on-board computer in a heated room and leave
it to dry.
Have your eBike checked by an expert at least once a year
(including mechanical parts, up-to-dateness of system soft-
ware).
In addition, the bicycle dealer may enter the service date
based on the distance travelled and/or on a period of time.
In this case, the on-board computer displays a message
telling you when the service date is due each time it is
switched on.
Please have your eBike serviced and repaired by an author-
ised bicycle dealer.
u Have all repairs performed only by an authorised bike
dealer.
Note: If you are handing in your eBike to a bicycle dealer for
maintenance, it is recommended that you temporarily deac-
tivate<Lock & Alarm>.
After-sales service and advice on using products
If you have any questions about the eBike and its compon-
ents, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com
.
Further information on the eBike components
and their functions can be found in the Bosch
eBike Help Center.
Transport
u If you transport your eBike attached to the outside of
your car, e.g. on a bike rack, remove the on-board
computer and the eBike battery (exception: built-in
eBike battery) to avoid damaging them.
Bosch eBike Systems 0 275 007 3BI | (23.02.2024)
To Next Page
Loading...
