Cube HYDE - Roller Training; Other Hazards; Hazards Caused by Faulty; Hazards Caused by Improper Use

14
|
OPERATING INSTRUCTIONS
2.2 Other hazards
2.2.1 Hazards caused by faulty nal
assembly
Risk of Personal Injury and Material
Damage!
Failure to observe the instructions con-
tained in this Operating instructions may
result in dangerous riding situations,
falling, accidents and material damage.
Have correct nal assembly and adjust-
ment of the right seat position for you
conrmed by your dealer. Use the printed
form in this Operating instructions on.
2.2.3 Risk of burns
Risk of Personal Injury and Material
Damage!
Risk of burns!
After long descents, the bicycle rims and
brake disks can get very hot.
•
Do not touch the rims or brake disks imme-
diately after a descent.
•
Let the rims and brake discs cool down
before you touch them.
•
In order to check the temperature, touch
the rims and brake disks very briey with
your bare nger. If they are hot, wait a few
minutes and repeat the test until the rims
and brake disks have cooled down.
2.1.7 Roller training
Risk of Personal Injury and Material
Damage!
If you do not observe the following inst-
ructions this can result in falls, accidents
and damage to property. Further infor-
mation can be found in our Service FAQ at
www.cube.eu/support/help-faq
QR CODE
•
Your CUBE bike is generally approved for
use with a indoor trainer, all pedelec models
(hybrid/EPAC) are excluded from this.
Please ensure that your bike is compatible
with the trainer, furthermore the installation
instruction of the respective trainer manu-
facturer must be observed.
2.2.2 Hazards caused by improper use
Risk of Personal Injury and Material
Damage!
Failure to observe the instructions con-
tained in this Operating instructions may
result in dangerous riding situations,
falling, accidents and material damage.
•
•
Please observe the instructions set out in
chapter 2.1.3
Always check if your bicycle meets the requi-
rements for its intended use (see chapters
2.1, 4.1)