Curtis Instruments 1351 - Decommissioning and Recycling the Controller

APPENDIX B — VEHICLE SYSTEM DESIGN CONSIDERATIONS-&-RECYCLING
pg. 133
Return to TOC Curtis Model 1351 – December 2018
Curtis controllers contain ESD-sensitive components. It is therefore necessary to protect them from
ESD damage. See Table 3 (page 12) for the controller ESD ratings.
ESD immunity is improved by providing sufficient distance or isolation between conductors and the
ESD source so that a discharge will not occur.
DECOMMISSIONING AND RECYCLING THE CONTROLLER
e controller is for installation into an Original Equipment Manufacturer (OEM) vehicle. Ideally,
as the system master installed as part of the specic vehicles’ electrical or electro-hydraulic control
system.
For controller decommissioning and recycling:
1. Follow the OEM’s vehicle decommissioning instructions.
2. Follow all applicable landll directives or regulations for Electrical and Electronic
Equipment (EEE) waste.