Curtis Instruments 1351 - System Controller Parameters

3 — PROGRAMMABLE PARAMETERS
pg. 33
Return to TOC Curtis Model 1351 – December 2018
THE PROGRAMMABLE PARAMETERS
e System Controller menu is where the 1351’s voltage (Power), battery discharge indicator (BDI),
5 and 12-volt power supplies (External Supplies), and the 1351’s Temperature parameters are located.
Note that within the parameter menus are read-only monitor variables which are helpful when setting
parameters and their aects. ese read only variables are italicized in this chapter’s menu index-
tables (e.g., in the System Controller table, below).
SYSTEM CONTROLLER
SYSTEM CONTROLLER
POWER.................................................... p. 34
—Keyswitch Voltage
—Nominal Voltage
—Max Voltage
—Min Voltage
—Brown Out Voltage
BDI........................................................ p. 35
—BDI Reading
—Reset Volts Per Cell
—Full Volts Per Cell
—Empty Volts Per Cell
—Discharge Time
— BDI Reset Percentage
EXTERNAL SUPPLIES............................. p. 36
—Ext 5V
—Ext 12V
—Ext 5V Current
—Ext 12V Current
—Ext 5V Enable
—Ext 12V Enable
TEMPERATURE....................................... p. 36
—Module Temperature
—Max Temp
—Min Temp