Curtis 1298 User Manual

64
Curtis 1298 Manual, OS 11
4a
4a — MONITOR MENU
MONITOR MENU
Through its Monitor menu, the 1311 programmer
provides access to real-time data during vehicle
operation. This information is helpful during
diagnostics and troubleshooting, and also while
adjusting programmable parameters.
MONITOR MENU
—Inputs ................. p. 64
—Outputs .............. p. 67
—Battery ............... p. 68
—Motor ................. p. 68
—Controller ........... p. 68
–Cutbacks ........ p. 70
–Motor Tuning .. p. 70
—Vehicle ............... p. 71
—CAN Status ........ p. 73
Monitor Menu: INPUTS
DISPLAY
VARIABLE RANGE DESCRIPTION
Throttle Command -100–100 % Throttle request to slew rate block.
Throttle_Command -32768–32767
Mapped Throttle -100–100 % Mapped throttle request.
Mapped_Throttle -32768–32767
Throttle Pot 0–5.5 V Voltage at throttle pot wiper (pin 16).
Throttle_Pot_Raw 0–36044
Brake Command 0–100 % Brake request to slew rate block.
Brake_Command 0–32767
Mapped Brake 0–100 % Mapped brake request.
Mapped_Brake 0–32767
Pot2 Raw 0–5.5 V Voltage at pot2 wiper (pin 17).
Pot2_Raw 0–36044
Mapped Hyd Throttle -100 – 100 % Mapped hydraulic throttle request to slew
Mapped_Hyd_Throttle -32767 – 32767 block (from lowering valve or pump).
Pump Throttle 0–100 % Pump throttle request after slew block.
Pump_Throttle 0–32767
PD Throttle 0–100 % Proportional driver current request.
PD_Throttle 0–32767
Steer Pot 0–5.5 V Voltage at steer pot wiper (pin 17) on Dual
Steer_Pot_Raw 0–36044 Drive traction slave.
Steer Angle -90 – 90 deg Steer angle calculated in Dual Drive
Steer_Angle -90 – 90 traction master.

Curtis 1298 Specifications

General

Brand	Curtis
Model	1298
Category	Controller
Language	English