Except during actual treatment, the system must always be in
STANDBY mode. Maintaining the system in STANDBY mode
prevents accidental treatment beam exposure if the footswitch is
inadvertently pressed.
Verify that all persons in the treatment room are wearing appropriate
treatment
beam safety eyewear before placing the system in
READY mode.
If the console is not used for three minutes, the system
automatically
reverts to STANDBY mode.
15
EXCEL HR OPERATOR MANUAL
D1796, REV. D, 12/16
755 nm Treatment Screen in READY Mode
WARNING
WARNING
NOTE
To Next Page
Loading...
