34
EXCEL HR OPERATOR MANUAL
D1796, REV. D, 12/16
Annual System Maintenance
Preventive maintenance, safety, power, and calibration checks should be performed annually by a
Cutera representative to ensure proper system performance.
System Repair
All system repairs should be performed by a Cutera-certified service engineer. For training and
information, contact Cutera Service (refer to Appendix C).
Routine User Maintenance
Clean the external surfaces of the system
console
Weekly, or as needed
Clean the system touchscreen
display
Weekly, or as needed
Inspect and clean the heat exchanger
intake
Inspect weekly; clean monthly, or as needed
Fill the coolant reservoir On installation or if water evaporates
Inspect and clean the handpiece During treatment, as needed, and between
patient use
Inspect and clean the handpiece holster Daily, or as needed
Cleaning the External Surfaces of the System Console
Use a cloth dampened with non-caustic cleaning solution, such as mild soap and water, isopropyl
alcohol, or a “hospital-grade” disinfectant, to wipe the external surfaces of the system console. Dry with
a clean cloth, or allow to air dry.
Do not attempt to gain access to any internal components. Electrical
shock
and/or unintended laser exposure may result. Do not spray or
pour cleaning agents directly on the system console.
Cleaning the System Touchscreen Display
Apply an alcohol-based cleaner to a soft cloth to clean the system touchscreen display.
Do not spray or pour cleaning agents directly on the system console
or
control screen. You may damage the console, touchscreen and
system electronics.
WARNING
CAUTION
To Next Page
Loading...
