CVC TECHNOLOGIES, INC. CVC 310 OPERATION MANUAL
Be sure that the operator knows the precise location of the emergency stop
button, so that it can be pressed in time upon any emergency situation. Before
machine start-up, also ensure that both the Stop Button and the Emergency stop
button are in “0” position.
Use caution while running aggressive or corrosive products, acid, caustic... etc.
Avoid splatters to machine or personnel.
Avoid touching machine moving or rotating parts with your body during
operation.
Cables around the machine should be properly laid inside trays to avoid
stumbles while walking, and thus preventing accidents.
Do not use screwdrivers or hammers to inspect the machine.
Switch off the power before setting up; only switch the machine on after setup is
properly done.
Shut down the machine after operation is finished by disconnecting all electrical
and air supply lines.
The manufacturer assumes no liability of any kind for danger which may be
brought about by misuse of the equipment or by applying the equipment to a
purpose other than that for which it is intended.
The equipment covered by this manual has been supplied for a particular
application. It is, therefore, imperative that the customer/owner contacts his/her
nearest agent or sales distributor before the equipment is used for any other
application.
Only products listed in the order confirmation may be processed by the
equipment covered by this instruction manual. Before processing any other kind
of product please contact your nearest agent or sales distributor.
3 - 4
To Next Page
Loading...
