CYBELEC DNC 60 PS User Manual

PAGE 10 USER GUIDE DNC 60 PS
- In other configurations, the provided start
button must be pressed.
- When the message TOL ZONE appears, that
means that a down command has been given
and that the axes are not positioned in the
current sequence. Give a start with the pro-
vided button or on the front panel of the
DNC.
Vy
Beam bending speed.
Programmed at 0, the speed is 1 mm/s.
Programmed at 9, the speed is 10 mm/s.
(If the machine is capable of reaching this speed)
Vy
Rising speed from BDC to CP.
Programmable from 0 (slow) to 9 (fast).
Allows to vary the speed at which the beam rises
to the CP. (Function depending on the machine's
hydraulics).
ΔT
Dwell time.
TDC
Distance from top dead centre.
SP
Distance from the beam speed changing point.
(Switch Point).
F1 - F5, Cr
Value of the auxiliary functions F1 to F5 and
crowning.
The auxiliary functions are displayed only if the
function is configured.
These fields can also be re-programmed by the user.
However, certain fields are related, that is modifying one provokes a
modification of the other.

CYBELEC DNC 60 PS Specifications

General

Brand	CYBELEC
Model	DNC 60 PS
Category	Control Systems
Language	English