CYBELEC DNC 60 PS User Manual

CREATING A PRODUCT PAGE 9
--MEM--
This column contains either the values calculated
by the system when simulating, or the values
programmed by the operator.
--POS--
This column indicates the real axes' positions.
--COR--
This column contains all the sequence and prod-
uct corrections introduced on the
CORRECTION page.
#The
, Y1, Y2, etc. fields are dependant on the axes programmed in
the numerical control.
L
Height of the wing after bending. The DNC will
automatically calculate the position of the back
gauge of axis X.
Q
Number of product sequence repetitions. Quan-
tity of products to be produced. The Q field is
displayed only if the parameter in the
PREFERENCES page is activated.
Lmat
Bending length.
TON
Bending force.
Rx
Back gauge retraction. The operator indicates in
mm the retraction distance. If nothing is pro-
grammed, the beam doesn't stop at the CP. No
retraction.
If value 0 is introduced, the beam stops at the
CP, then executes immediately the bend without
carrying out a retraction.
The field between the Rx and the retraction
value serves to define the retraction mode.
_ = the beam stops at the CP and waits till the
retraction is made, in order to carry out the
bend.
1 = the beam stops at the CP, then continues
immediately, at the same time as the retrac-
tion is carrying out.
Ext start
If nothing is programmed in this field, the axes
start automatically from the BDC, from the CP
or from the TDC, depending on the choice made
in the machine parameters.
If 1 is programmed, the start will be made as a
function of the configuration made by the con-
structor.
- In most of the configurations, it will be suffi-
cient to give a down command. At this com-
mand, the axes take position, then a second
down command has to be given, in order to
move the beam.
L

CYBELEC DNC 60 PS Specifications

General

Brand	CYBELEC
Model	DNC 60 PS
Category	Control Systems
Language	English