CYBELEC DNC 60 PS User Manual

ANNEX G: SUNDRIES PAGE 57
7) Enter:
- value
1 in the Clear variables zone field,
- value
1 in the Clear machine parameters zone field
- value
817 in the EXECUTION CODE field.
Press the
key.
Press the
key twice.
8) Enter:
value
1 in the field Clear variables zone,
value
1 in the field Clear machine parameters zone,
value
1 in the field Clear transmission RS232 zone
and value
817 in the field EXECUTION CODE.
Press the
key.
Press the
key twice.
Clearing the machine parameters also deletes all the input / output configura-
tion defined by the operator.
We therefore recommend that the DNC 60 be re-configured before next use.
Important: If you use an external system for re-entering data (CYBACK
via RS232) and the problem persists, then the information re-entered by this
system have to checked again.
The best thing to do in this case is to again delete the whole contents of the
DNC and to re-program the DNC manually via the keyboard (not the RS232
line).
BEFORE CALLING FOR TECHNICAL HELP
Please have ready the following information:
 Type of numerical control.
 Serial Nr of the DNC.
 DNC and axes (N2X) software numbers.
 Name of the machine tool's manufacturer.
 List of machine parameters (have on hand when the technician
comes).
 The state of the numerical control:
- which LEDs are on?
- which message is on the screen ?
 Details of what caused or is causing the problem.

CYBELEC DNC 60 PS Specifications

General

Brand	CYBELEC
Model	DNC 60 PS
Category	Control Systems
Language	English