D-Link DCS-935L - Mail

38D-Link DCS-935L User Manual
Section 4 - Conguration
Mail
Thissectionallowsyoutocongureyourcameratosendsnapshotsandvideoclipstoane-mailaddress.Ifyouarenotsurewhatsettingstouse,
checkwithyoure-mailprovider(e.g.,Gmail,YahooMail,etc.).
SMTP Server
Address:
SMTP Server
Port:
Sender E-mail
Address:
Receiver E-mail
Address:
User Name:
Password:
Use SSL-TLS/
STARTTLS
EnterthedomainnameorIPaddressofyourexternale-mailserver.
Entertheportnumberusedbyyourexternale-mailserver.(Thedefaultvalue
is25.)
Enter the E-mail Address listed as the sender for your notication e-mails.
Enter the E-mail Address that your notication e-mails will be sent to.
IftheSMTPserverusesauthentication,enteryourUser Name.
IftheSMTPserverusesauthentication,enteryourPassword.
Select one of these choicesifyourSMTPserverrequiresSSL-TLSorSTARTTLS
authentication.Forexample,ifyouwanttouseGmailwithSSL-TLSfore-mail
notications, you can follow the steps below:
Step 1 - Enter smtp.gmail.com in SMTP Server Address eld.
Step 2 - Change the SMTP Server Port number from 25 to 465.
Step 3 - Enter your Gmail e-mail address in the Sender E-mail Address.
Step 4 - Enter the destination e-mail address in Receiver E-mail Address.
Step 5 - Enter the User NamerequiredtoaccesstheSMTPserver.
Step 6 - Enter the PasswordrequiredtoaccesstheSMTPserver.
Step 7 -SelectSSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail.
Note: You can also use STARTTLS, which will use SMTP server port number 587. If you
want to use a Yahoo SMTP server, the SMTP server address will be dierent between
each registered region, and only SMTP port 465 is supported for SSL-TLS.
Click Save Settings to save your changes.