D-Link DFL-870

Parameters command"
response
Context Parameters ALG Module Name
ALG Session ID
2.1.181. base64_decode_failed (ID: 00200386)
Default Severity ERROR
Log Message POP3ALG: Base 64 decode failed. Attachment blocked
Explanation The data sent to Base64 decoding failed. This can occur if the email
sender sends incorrectly formatted data. The attachment has been
blocked.
Gateway Action block_data
Recommended Action Research how the sender is encoding the data.
Revision 1
Parameters filename
filetype
sender_email_address
Context Parameters ALG Module Name
ALG Session ID
2.1.182. possible_invalid_mail_end (ID: 00200387)
Default Severity WARNING
Log Message POP3ALG: Possible invalid end of mail "\\n.\\n" received.
Explanation The client is sending possible invalid end of mail.
Gateway Action allow
Recommended Action Research how the client is sending possible invalid end of mail.
Revision 1
Parameters sender_email_address
Context Parameters ALG Module Name
ALG Session ID
2.1.183. command_blocked_invalid_len (ID: 00200388)
Default Severity WARNING
Log Message POP3ALG: Command line blocked,line begins with linebegin. Invalid
line length <len>
Chapter 2: Log Message Reference
117