2.39. NATPOOL
These log messages refer to the NATPOOL (Events related to NAT Pools) category.
2.39.1. uninitialized_ippool (ID: 05600001)
Default Severity ERROR
Log Message NATPool <poolname> has not been initialized
Explanation The NATPool is not initialized. This can happen if the NATPool
contains no valid IP addresses. If the NATPool is configured to use an
IPPool, no IP addresses have been received form the IPPool.
Gateway Action drop
Recommended Action If the NATPool is configured to use an IPPool, verify that addresses
have been loaded from IPPool.
Revision 1
Parameters poolname
2.39.2. removed_translation_address (ID: 05600002)
Default Severity WARNING
Log Message Translation IP address <address> does no longer exist in NATPool
<poolname>
Explanation The translation IP has been removed by a configuration change. The
connection is no longer valid and will be closed.
Gateway Action close
Recommended Action None.
Revision 1
Parameters address
poolname
2.39.3. reconf_state_violation (ID: 05600003)
Default Severity NOTICE
Log Message State violation during re-mapping to STATFUL NATPool
<poolname>.
Explanation The NATPool's configuration has changed to STATEFUL. This
connection's translation IP violates the stateful NATPool. Connection
will remain open but will no longer be attached to this NATPool.
Gateway Action decouple
Chapter 2: Log Message Reference
469
To Next Page
Loading...
