D-Link xStack DES-3200 Series - Page 100

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
95
show syslog host
Used to displ
ay the syslog hosts currently configured on the Switch.
Purpose
sho
w syslog host {<index 1-4>}
Syntax
This
command is used to display the syslog hosts that are currently
configured on the Switch.
Description
Parameters
<index 1-4>  Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
Non
e.
Restrictions
Example usage:
To show syslog host information:
DES-3200-28:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address Severity Facility UDP port Status
------- --------------- -------------- -------- -------- --------
1 10.1.1.2 All Local0 514 Disabled
2 10.40.2.3 All Local0 514 Disabled
3 10.21.13.1 All Local0 514 Disabled
Total Entries : 3
DES-3200-28:4#