xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
94
Exam
ple usage:
To configure a syslog host:
DES-3200-28:4#config syslog host 1 severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3200-28:4#
To configure a syslog host for all hosts:
DES-3200-28:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DES-3200-28:4#
delete syslog host
Used to rem
ove a syslog host that has been previously configured,
from the Switch.
Purpose
delete sy
slog host [<index 1-4> | all]
Syntax
This
command is used to remove a syslog host that has been
previously configured from the Switch.
Description
Parameters
<index 1-4> Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all Specifies that the command will be applied to all hosts.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete a previously configured syslog host:
DES-3200-28:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3200-28:4#
To Next Page
Loading...
