xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
10
8
config stp mst_config_id
Used to upd
ate the MSTP configuration identification.
Purpose
config
stp mst_config_id {revision_level <int 0-65535> | name <string>}
Syntax
This
command is used to uniquely identify the MSTP configuration currently configured
on the Switch. Information entered here will be attached to BPDU packets as an identifier
for the MSTP region to which it belongs. Switches having the same revision_level and
name will be considered as part of the same MSTP region.
Description
revisio
n_level <int 0-65535> – Enter a number between 0 and 65535 to identify the
MSTP region. This value, along with the name will identify the MSTP region configured
on the Switch. The default setting is 0.
Parameters
name <string> Enter an alphanumeric string of up to 32 characters to uniquely identify
the MSTP region on the Switch. This name, along with the revision_level value will
identify the MSTP region configured on the Switch. If no name is entered, the default
name will be the MAC address of the device.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the MSTP region of the Switch with revision level 10 and the name “DLee”:
DES-3200-28:4#config stp mst_config_id revision_level 10 name DLee
Command: config stp mst_config_id revision_level 10 name DLee
Success.
DES-3200-28:4#
To Next Page
Loading...
Need help?
General
