xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
15
7
DES-3200-28:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DES-3200-28:4#
delete link_aggregation group_id
Used to delet
e a previously configured link aggregation group.
Purpose
delete lin
k_aggregation group_id <value>
Syntax
This
command is used to delete a previously configured link
aggregation group.
Description
Parameters
<value> Specifies the group ID. The Switch allows up to 14 link
aggregation groups to be configured. The group number identifies
each of the groups.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete link aggregation group:
DES-3200-28:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DES-3200-28:4#
config link_aggregation
Used to co
nfigure a previously created link aggregation group.
Purpose
config lin
k_aggregation group_id <value> {master_port <port> | ports
<portlist> | state [enable | disable]} (1)
Syntax
This
command is used to configure a link aggregation group that was
created with the create link_aggregation command above.
Description
Parameters
group _id <value> Specifies the group ID. The Switch allows up to
14 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port <port> Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of the
ports in a link aggregation group will share the port configuration with
the master port.
ports <portlist> Specifies a port or range of ports that will belong to
the link aggregation group.
state [enable | disable] Allows users to enable or disable the
specified link aggregation group.
Only Administrator-level users can i
ssue this command. Link
aggregation groups may not overlap.
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 1 with group members ports 1 through 4:
To Next Page
Loading...
