xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
15
8
DES-3200-28:4#config link_aggregation group_id 1 master_port 1 ports 1-4
Command: config link_aggregation group_id 1 master_port 1 ports 1-4
Success.
DES-3200-28:4#
config link_aggregation algorithm
Used to co
nfigure the link aggregation algorithm.
Purpose
config lin
k_aggregation algorithm [mac_source | mac_destination |
mac_source_dest | ip_source | ip_destination | ip_source_dest]
Syntax
This
command is used to configure the part of the packet examined by the
Switch when selecting the egress port for transmitting load-sharing data.
This feature is only available using the address-based load-sharing
algorithm.
Description
Parameters
mac_source Indicates that the Switch should examine the MAC source
address.
mac_destination Indicates that the Switch should examine the MAC
destination address.
mac_source_dest Indicates that the Switch should examine the MAC
source and destination addresses
ip_source Indicates that the Switch should examine the IP source
address.
ip_destination Indicates that the Switch should examine the IP
destination address.
ip_source_dest Indicates that the Switch should examine the IP source
and destination addresses
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DES-3200-28:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DES-3200-28:4#
show link_aggregation
Used to displ
ay the current link aggregation configuration on the
Switch.
Purpose
sho
w link_aggregation {group_id <value> | algorithm}
Syntax
This
command is used to display the current link aggregation
configuration of the Switch.
Description
Parameters
<value> Specifies the group ID. The Switch allows up to 14 link
aggregation groups to be configured. The group number identifies
each of the groups.
algorithm Allows users to specify the display of link aggregation
To Next Page
Loading...
Need help?
General
