D-Link xStack DES-3200 Series - Page 198

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
19
3
Example usage:
To display the 802.1X authentication state for host-based 802.1X:
DES-3200-28:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port Number : 1
Index MAC Address Auth PAE State Backend State Port Status
------ ----------------- -------------- ------------- ------------
1 00-80-C8-4D-4E-0A Connecting Idle Unauthorized
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
config 802.1x auth_mode
Used to co
nfigure the 802.1X authentication mode on the Switch.
Purpose
config 8
02.1x auth_mode [port_based | mac_based]
Syntax
This
command is used to enable either the port-based or Host-based
802.1X authentication feature on the Switch.
Description
Parameters
[port_based | mac_based]  The Switch allows users to authenticate
802.1X by either port or MAC address.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure 802.1X authentication by MAC address:
DES-3200-28:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3200-28:4#