D-Link xStack DES-3200 Series - Page 203

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
19
8
config radius add
Used to configure the
settings the Switch will use to communicate with a RADIUS
server.
Purpose
config radiu
s add <server_index 1-3> [<server_ip>] key <passwd 32> [default |
{auth_port <udp_port_number 1-65535> | acct_port <udp_port_number 1-65535> |
timeout <int 1-255> | retransmit <int 1-255>} (1) ]
Syntax
This
command is used to configure the settings the Switch will use to communicate
with a RADIUS server.
Description
Parameters
<server_index 1-3>  Assigns a number to the current set of RADIUS server settings.
Up to three groups of RADIUS server settings can be entered on the Switch.
<server_ip>  The IP address of the RADIUS server.
key  Specifies that a password and encryption key will be used between the Switch
and the RADIUS server.
<passwd 32>  The shared-secret key used by the RADIUS server and the Switch. Up
to 32 characters can be used.
default  Uses the default UDP port number in both the “auth_port” and “acct_port”
settings.
auth_port <udp_port_number 1-65535>  The UDP port number for authentication
requests. The default is 1812.
acct_port <udp_port_number 1-65535>  The UDP port number for accounting
requests. The default is 1813.
timeout <int 1-255>  The time in second for waiting server reply.
The default value is 5 seconds.
retransmit <int 1-255>  The count for re-transmit. The default value is 2.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the RADIUS server communication settings:
DES-3200-28:4#config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
DES-3200-28:4#