D-Link xStack DES-3200 Series - Page 204

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
19
9
config radius delete
Used to delet
e a previously entered RADIUS server configuration.
Purpose
config radiu
s delete <server_index 1-3>
Syntax
This
command is used to delete a previously entered RADIUS server
configuration.
Description
Parameters
<server_index 1-3>  Assigns a number to the current set of
RADIUS server settings. Up to three groups of RADIUS server
settings can be entered on the Switch.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete previously configured RADIUS server communication settings:
DES-3200-28:4#config radius delete 1
Command: config radius delete 1
Success.
DES-3200-28:4#
config radius
Used to co
nfigure the Switch’s RADIUS settings.
Purpose
config radiu
s <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> [auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>] | timeout <int 1-255> | retransmit <int
1-255>} (1)
Syntax
This
command is used to configure the Switch’s RADIUS settings.
Description
Parameters
<server_index 1-3>  Assigns a number to the current set of
RADIUS server settings. Up to three groups of RADIUS server
settings can be entered on the Switch.
ipaddress <server_ip>  The IP address of the RADIUS server.
key  Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
<passwd 32>  The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
auth_port <udp_port_number 1-65535>  The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535>  The UDP port number for
accounting requests. The default is 1813.
timeout <int 1-255>  The time in second for waiting server reply.
The default value is 5 seconds.
retransmit <int 1-255>  The count for re-transmit. The default value
is 2.
Only Administrator-level users
can issue this command.
Restrictions