D-Link xStack DES-3200 Series - Page 230

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
22
5
DES-3200-28:4#show cpu_access_profile
Command: show cpu_access_profile
CPU Interface Filtering state: Enabled
Access Profile Table
================================================================================
Profile ID: 1 Type: IPv4 Frame Filter - ICMP
================================================================================
Owner: ACL
Masks Option
VLAN Source IP Dest. IP DSCP Prot Type Code
---------------- --------------- --------------- ---- ---- ---- ----
0xFFF 20.0.0.0 10.0.0.0 ICMP
--------------------------------------------------------------------------------
Access ID : 3
Ports : 1-10
Mode : Deny
VLAN Name Source IP Dest. IP DSCP Prot Type Code
Mask Mask Mask
---------------- --------------- --------------- ---- ---- ---- ----
default (0x1) 20.0.0.0 10.0.0.0 3 ICMP 11 32
================================================================================
Total Profile Entries: 1
Total Rule Entries: 1
enable cpu_interface_filtering
Used to ena
ble CPU interface filtering on the Switch.
Purpose
enabl
e cpu_interface_filtering
Syntax
This
command is used, in conjunction with the disable
cpu_interface_filtering command below, to enable and disable CPU
interface filtering on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example Usage:
To enable CPU interface filtering:
DES-3200-28:4#enable cpu_interface_filtering
Command: enable cpu_interface_filtering
Success.
DES-3200-28:4#